All,
I can find several places that lists the G1 Contender Carbine Forend using a 10-32 screw but I need to know the length? Thanks!
All,
I can find several places that lists the G1 Contender Carbine Forend using a 10-32 screw but I need to know the length? Thanks!
There were many variations in forends over the years so it's not a one size fits all. As Marlinman suggested the thing to do is start long and trim to fit. The thing to watch is to make sure the screw doesn't bottom on the barrel as it can pull/jack the dovetail lock loose.
+1 on finding a longer screw and then shortening it. This is how I do (FWIW) it. Find your screw. Take a piece of thin scrap material and drill and tap it for the thread of the screw. Figure out how long it needs to be and then insert it into the scrap with extra screw length sticking out. Grind to length and then as you remove the screw to use in the for-end, the threads are chased out perfectly, all ready for use. Just my two centavos. Good luck.
Found the correct thread but all the heads were too big from the selection at Lowes. Since I'll most likely sell this set up I didn't want to drill the forearm or fabricate screws. Thanks for the hints.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |